The USB to MAC Ethernet Controller is a unique solution
to interface peripheral devices to Universal Serial
Bus 2.0 (USB 2.0) and 10/100 Base -T Ethernet. This
device has been specially designed to provide simple
solution to communicate with Ethernet applications accomplished
by its highly integrated functionality. It is ideal
for LAN (Local Area Network) applications. It provides
internal buffering to enable parallel operations from
USB ports on host side and MAC ports on the Ethernet
bus. It also provides serial interface for EEPROM storing
device ID.
|
|
Fully IEEE 802.3
compliant 10/100 Mbps Ethernet MAC layer
|
|
|
USB specification
2.0 compliant |
|
|
Extensive Driver Support
|
|
|
Supports all USB standard commands
|
|
|
Supports three vendor specific
commands
|
|
|
Supports USB Suspend/Resume detection
logic
|
|
|
Supports chirping and ping protocol
|
|
|
Supports remote wakeup (wake on
LAN)
|
|
|
Provides
full duplex operation on both 100 Mbps and 10 Mbps
Ethernet modes |
|
|
Exhaustive
MAC status report |
|
|
Supports
PAUSE control frame |
|
|
Provides
serial interface for read 93LC46B EEPROM |
|
|
Automatically
loads device ID from EEPROM after power-on reset |
|
|
EEPROM can
be programmed through USB port |
